Randall Posted March 6, 2023 Report Share Posted March 6, 2023 Hello, I recently purchased the CivicLink HC92x G4+ Plug In ECU for my set up. This is my first standalone engine management unit, and I understand its has CAN capabilities I would like to take advantage of. As far as using the Link CAN Wideband 02 sensor, which wiring harness/es do I need to run this unit? I have received multiple answers and none are consistent making it hard for me to determine what exactly I need to purchase. Further more, if I would like to add a CAN Gauge as well, what would be needed there? Thanks a million for the assistance. Quote Link to comment Share on other sites More sharing options...
Adamw Posted March 7, 2023 Report Share Posted March 7, 2023 You would want a CANJST to bring CAN outside of the ECU case. Then you will probably want a CANEXT (extension cable) to reach to the Lambda controller. If you want 2 devices then you would split the bus using a CANTEE somewhere and you would possibly need a further CANEXT depending on locations etc. MR GTR 1 Quote Link to comment Share on other sites More sharing options...
Randall Posted March 10, 2023 Author Report Share Posted March 10, 2023 Thanks a million for the response. Parts have been ordered! Quote Link to comment Share on other sites More sharing options...
Randall Posted March 30, 2023 Author Report Share Posted March 30, 2023 On 3/7/2023 at 3:12 PM, Adamw said: You would want a CANJST to bring CAN outside of the ECU case. Then you will probably want a CANEXT (extension cable) to reach to the Lambda controller. If you want 2 devices then you would split the bus using a CANTEE somewhere and you would possibly need a further CANEXT depending on locations etc. So I have these connections & im having issue setting up the CANLambda. Im not running the Gauge at the moment just the Lambda, & I have it connected to the ECU with the CANJST. 12v of switched power is going to the red lead & the black is grounded. We can walk through the steps & set the sensor up using the instructions, but when the power is cycled off & the car started we aren’t getting a reading from the Lambda. Any suggestions? Have tried using Can1 & Can2 in the setup menu. Quote Link to comment Share on other sites More sharing options...
koracing Posted April 3, 2023 Report Share Posted April 3, 2023 I see you got this resolved here: Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.