Håvard Karlsen Posted April 21, 2024 Report Posted April 21, 2024 Why is the DI 8 Active when the switch is off? (Not in use) Quote
Adamw Posted April 21, 2024 Report Posted April 21, 2024 Just a quirk of the G4+ software. You can temporarily set it to gp input and turn the pull-up off, then set it back to off. Quote
Håvard Karlsen Posted April 21, 2024 Author Report Posted April 21, 2024 I do have a 4D fuel table on my g4+. I tought it was always on. But i found that it was switched to DI-8. I do not know how that happened. Was the table active because of that DI-8 reads «active»? The pullup was off… Quote
Adamw Posted April 21, 2024 Report Posted April 21, 2024 No, the table would not have been active with DI8 off. It is only the status display in PC Link that doesnt update after an input is turned off. Quote
Håvard Karlsen Posted April 21, 2024 Author Report Posted April 21, 2024 7 minutes ago, Adamw said: No, the table would not have been active with DI8 off. It is only the status display in PC Link that doesnt update after an input is turned off. Okei- the green «active» will not turn off. Do i need to be conected to the ecu? Quote
Vaughan Posted April 21, 2024 Report Posted April 21, 2024 21 minutes ago, Håvard Karlsen said: Okei- the green «active» will not turn off. Do i need to be conected to the ecu? yes, runtimes are only updated by the ECU, not by PCLink Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.