Jason LeBlanc Posted October 10, 2010 Report Share Posted October 10, 2010 Help hopefully, I have a G1 / V10 with a ser # of 001360on the board, the sticker on the case is as : SUBARU / LPV10 / 200203 I have the 6 wire isc board installed with the switch in the off/1 position, .... I resently sent this to a LINK repair shop here in the states & had all repairs made to have a clean bill of health last week I installed this unit into my DD which uses a 3 wire ISC setup ,in which I wired the loom to accept this & operate correctly ? I tried it in the race car which uses a similar ISC to the 6 wire used on the USDM 2.5 ,But only has 3 wires as simmilar to the ISC used on the USDM 1.8 TB & it operated satisfactory, Is there a different board for the 3 wire ISC that is used on the ej20 g & ej20k & ej22t ?? All help is appreciated Jay Quote Link to comment Share on other sites More sharing options...
Simon Posted October 15, 2010 Report Share Posted October 15, 2010 For two or 3 wire solenoids the board for the 6T stepper should be removed. With this removed the 3 wire ISC should perform as expected. Quote Link to comment Share on other sites More sharing options...
Kyle McAwesome Posted October 27, 2010 Report Share Posted October 27, 2010 wow if you have a 6 wire stepper sub board that you have to remove anyways get a hold of me. i am having troubles with mine because i have a 6wire and i dont think i have the 6wire board. thanks mark Quote Link to comment Share on other sites More sharing options...
Jurgen Biggelaar Posted November 23, 2010 Report Share Posted November 23, 2010 Did you end up getting this PCB for ISC control Kyle? Jurgen Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.