c0op3r Posted August 23, 2016 Report Share Posted August 23, 2016 I would like to see a pre-configuration for the Zeitronix WideBand Gauges:http://www.zeitronix.com/The Z3-2 and the Zt-3 (which are basically the same device). Quote Link to comment Share on other sites More sharing options...
Scott Posted August 23, 2016 Report Share Posted August 23, 2016 Hi Cooper,The calibration looks to be readily available which makes the job easier. I will ask the engineers to consider adding the calibration.Scott. TTP 1 Quote Link to comment Share on other sites More sharing options...
Aqmar Posted June 25, 2019 Report Share Posted June 25, 2019 i have one of those..Zeitronix ZT2. Is there away from me to recalibrate it? because i receive ECU Fault Code 20: An Volt 4 below Error Low value which refer to my wideband sensor Quote Link to comment Share on other sites More sharing options...
Simon Posted June 25, 2019 Report Share Posted June 25, 2019 If the unit runs full scale then the way to avoid this is to set you error low value to 0. This will stop the ECU fault code. Quote Link to comment Share on other sites More sharing options...
Aqmar Posted June 27, 2019 Report Share Posted June 27, 2019 Dear @Simon, Sorry i am actually quite new and still learning. So just to be clear.. 1) How to know that my unit run full scale? 2) Attached below is my wideband configuration table. . - And also i attached the calibration table provide in Link G4+ help manual. 3) So based on my configuration table with reference to the table provide by Link G4+ manual, the low value here refer to 'Low Voltage' or 'Low Lambda'? In my configuration table, i register AnV4 Error Low = 0.05 and AnV4 Error Value = 0.000lambda..Which should i corect it? Quote Link to comment Share on other sites More sharing options...
Adamw Posted June 27, 2019 Report Share Posted June 27, 2019 As per Simon's advice, you need to set the error low to 0.00. Quote Link to comment Share on other sites More sharing options...
Aqmar Posted August 24, 2019 Report Share Posted August 24, 2019 Thank you. Yes you r right. Problem solve! Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.