Rosello Posted February 25, 2017 Report Share Posted February 25, 2017 (edited) Hi guys look my picture thank you for your help Edited February 25, 2017 by Rosello Quote Link to comment Share on other sites More sharing options...
Adamw Posted February 26, 2017 Report Share Posted February 26, 2017 Hi Rosello.No you do not need to connect to the ECU ground. The 12V and GND is only needed to power the wifi device, it is not needed for communication. It looks to me like your problem is you have used the USB tuning port, not the CAN port. Quote Link to comment Share on other sites More sharing options...
Rosello Posted February 26, 2017 Author Report Share Posted February 26, 2017 (edited) Ok thank you, where to buy the cable for port CAN RS232? I don't find? Edited February 26, 2017 by Rosello Quote Link to comment Share on other sites More sharing options...
Rosello Posted February 26, 2017 Author Report Share Posted February 26, 2017 Help please? Quote Link to comment Share on other sites More sharing options...
Adamw Posted February 26, 2017 Report Share Posted February 26, 2017 Same cable - the part number is CANPCB. You can order it through a dealer. In the meantime you can unplug the USB cable and plug it in to the can port connector. Quote Link to comment Share on other sites More sharing options...
Rosello Posted February 26, 2017 Author Report Share Posted February 26, 2017 ok thank you so much, but i need modify mode? Quote Link to comment Share on other sites More sharing options...
Adamw Posted February 27, 2017 Report Share Posted February 27, 2017 Set it like below. You might need to try 250 kbit/s bit rate if your device doesnt work at 500. Quote Link to comment Share on other sites More sharing options...
Rosello Posted February 27, 2017 Author Report Share Posted February 27, 2017 Ok thank you i'm going to try Quote Link to comment Share on other sites More sharing options...
Rosello Posted March 7, 2017 Author Report Share Posted March 7, 2017 (edited) "No you do not need to connect to the ECU ground. The 12V and GND is only needed to power the wifi device, it is not needed for communication. " Are you sure?because look it's write "connect to ecu signal ground" Edited March 7, 2017 by Rosello Quote Link to comment Share on other sites More sharing options...
Simon Posted March 7, 2017 Report Share Posted March 7, 2017 It is only for power to the device so any ground will do the trick. Quote Link to comment Share on other sites More sharing options...
Rosello Posted March 8, 2017 Author Report Share Posted March 8, 2017 Ok thank you Quote Link to comment Share on other sites More sharing options...
Rosello Posted March 15, 2017 Author Report Share Posted March 15, 2017 I have a probleme where is can setup? Quote Link to comment Share on other sites More sharing options...
Adamw Posted March 15, 2017 Report Share Posted March 15, 2017 Your ecu is password protected. You will have to get the password from whoever locked it. Quote Link to comment Share on other sites More sharing options...
Rosello Posted March 15, 2017 Author Report Share Posted March 15, 2017 F...k!! thank you Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.