iecku.tavea racing Posted April 24, 2017 Report Share Posted April 24, 2017 (edited) HeyI am looking to connect a can-egt module to a link g4+ extreme red which has currently a link display on its output port. Could i just wire the can-egt to can H and can L and configure it like in the picture below? Edited April 24, 2017 by iecku Quote Link to comment Share on other sites More sharing options...
Adamw Posted April 25, 2017 Report Share Posted April 25, 2017 No, as far as I know these two devices require different baud rates and neither is configurable. The DIY EGT needs 500kb and Displaylink needs 1Mb. You cant have different speeds on the same CAN bus. You will have to move one of them to CAN 2. Quote Link to comment Share on other sites More sharing options...
iecku.tavea racing Posted May 4, 2017 Author Report Share Posted May 4, 2017 i am nt sure if i can use the CAN2 module with this ecu!? Quote Link to comment Share on other sites More sharing options...
Simon Posted May 4, 2017 Report Share Posted May 4, 2017 Unfortunately CAN 2 is not an option as it was only added on later hardware (version 1.4) Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.