Nick1512 Posted June 19, 2018 Report Share Posted June 19, 2018 Hey guys I’ve just bought a Link Atom g4+ and I’m looking to wire it into my 3RZFE-T hilux. I’m looking to change the ignition over to direct fire using LS1 coil packs. I’ve looked in the manual and it describes 1 of the 4 pins on the coil pack as ‘signal ground’ might be a dumb question but does that just get grounded to the body same as the power ground? Also the trigger wires, pin 7 is a shield/ground is that only used if the trigger is a 3 wire trigger or can I use it for the trigger grounds? Any help would be great! Thanks Nick Quote Link to comment Share on other sites More sharing options...
Brad Burnett Posted June 19, 2018 Report Share Posted June 19, 2018 4 wires. A chassis ground B sensor ground C signal from ecu D +12v switched Quote Link to comment Share on other sites More sharing options...
Adamw Posted June 19, 2018 Report Share Posted June 19, 2018 Yes Pin 7 is normally used to ground the trigger sensors and the shield for them. So 4 ground wires would all be spliced together to this pin. Quote Link to comment Share on other sites More sharing options...
Nick1512 Posted June 19, 2018 Author Report Share Posted June 19, 2018 Perfect thanks guys! Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.