chris.p Posted August 15, 2018 Report Share Posted August 15, 2018 hi im wondering if anyone has had similar issues with their idle speed control It doesnt work.... Its a 3 pin bmw e36 valve, using a power probe ive tested the full operation off the car and it opens and shuts perfectly . ive wired it with a common 12v and wired the other two pins to Aux1-2 with the close on 1 set to "sol slave" and the open to Aux2 set to "Sol" as instructed but it doesnt fuction . if i run and output test on aux 1 or 2 the valve does operate Fury g4+ ecu regards chris Quote Link to comment Share on other sites More sharing options...
Brad Burnett Posted August 15, 2018 Report Share Posted August 15, 2018 You will get better help here if you were to post a calibration file with the question. But I just recently ran into a similar predicament. Check that your max and min clamps on the idle tab are set to reasonable values. The base cal in the atom I installed this past week had the max clamp at 12ish and it wouldn't operate. Quote Link to comment Share on other sites More sharing options...
chris.p Posted August 15, 2018 Author Report Share Posted August 15, 2018 thanks ill attach it E36 m50 non vanos 2800 8.5-1 gtx35 BASE.pclr Quote Link to comment Share on other sites More sharing options...
Brad Burnett Posted August 15, 2018 Report Share Posted August 15, 2018 clamps are fine. It may be that your have speed lock out set to driven wheel speed, but driven wheel speed is not configd in speed sources. Quote Link to comment Share on other sites More sharing options...
chris.p Posted August 15, 2018 Author Report Share Posted August 15, 2018 ill adjust that lockout good spot , im getting speed off a driven wheel but had to tell it it was non driven so i got the speed via can to the dash2 . i will add a non driven after its fully tuned so i can set a decent 2 step up ill fill you in on this .... Quote Link to comment Share on other sites More sharing options...
Brad Burnett Posted August 15, 2018 Report Share Posted August 15, 2018 you can set both driven and non driven to the same wheel speed sensor. Quote Link to comment Share on other sites More sharing options...
Adamw Posted August 16, 2018 Report Share Posted August 16, 2018 Change your aux 2 frequency to 200Hz. I tested your map on the bench and it is working fine for me (even without the driven wheel speed setup). A special note about those Bosch valves is the min clamp needs to be 10-15%, fully closed is usually around 10%DC, if you reduce the DC below this the valve actually starts to open again. Some notes from the help file about setting these up (basically same as the 2 wire): Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.