Grant Baker Posted April 3, 2019 Report Share Posted April 3, 2019 Hi Customer has brought me an EVO 8 to fit a plugin G4+ and he has fitted an Innovate MTX-D Oil Pressure / Temp gauge. He's not keen on fitting "more sensors" to the car, so wants us to use the gauge output... Easy you say? Well no... It's not got analogue outs! Only the MTS Data stream. So, I'm guessing the MTS stream is not able to be input to the G4+, therefore I need to piggy back the pressure and temp sensors. Anybody done this? Any tricks needed? Quote Link to comment Share on other sites More sharing options...
Richard Hill Posted April 3, 2019 Report Share Posted April 3, 2019 I have piggy backed several sensors, pin the sensor signal wire into an analogue volt input. Select a suitable calibration type (often linear for pressure and table for temperature) , then run the sensor up as high as possible and note the calibrated reading on the gauge versus the voltage in pc link. Linear sensors will be ratiometric. For non linear sensors I create a spreadsheet and then curve fit the temperature data . It often exhibits a logarithmic response. HTH, Richard. Quote Link to comment Share on other sites More sharing options...
Grant Baker Posted April 3, 2019 Author Report Share Posted April 3, 2019 Great - thanks. Temp sensor into an AN Volt as well?? Quote Link to comment Share on other sites More sharing options...
Adamw Posted April 4, 2019 Report Share Posted April 4, 2019 Actually it's not possible to share sensors with MTX-D, it does something fruity measuring all sensors using a single ADC and switches the pull-up on/off when it takes the measurement. See this post for more info: Quote Link to comment Share on other sites More sharing options...
Stower93 Posted November 16, 2019 Report Share Posted November 16, 2019 So is it possible to just run the sensors straight to the ecu? Without the use of the gauges. If so, would any settings need to be changed when you switch the an channel on? Like the calibration, an low, high and error values?? Quote Link to comment Share on other sites More sharing options...
Adamw Posted November 16, 2019 Report Share Posted November 16, 2019 Is yours the newer one with the 3 wire pressure sensor or the older 2 wire one? Quote Link to comment Share on other sites More sharing options...
Stower93 Posted November 17, 2019 Report Share Posted November 17, 2019 Pressure sensor is 3 wire and temp sensor is 2 wire Quote Link to comment Share on other sites More sharing options...
Stower93 Posted November 20, 2019 Report Share Posted November 20, 2019 So would the senors be ok to use? Wouldnt mind hooking them up so i can get some data Quote Link to comment Share on other sites More sharing options...
Adamw Posted November 20, 2019 Report Share Posted November 20, 2019 Yes, although the calibration is unknown so you will have to do some trial and error to work out the calibrations. The temp sensor will likely use the AC Delphi calibration. Pressure sensor will need to be wired to 5V, sensor ground and an analog input (pinout unknown but should be able to work it out from gauge wiring). Temp sensor will be wired to sensor gnd and a temp input (either way around). Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.