neil brown

can the g1 ecu support boost limiting in gear  will be running a ppg 5 speed gearbox with 1.8 bar of boost, but it has a standard uk 5th gear cog and dont think it will link it will like 1.8 bar of boost  can this ecu has spare input wire to activate a low boost setting ?

just to clarify  each injector has a common 12v feed and each switch wire goes back to the ecu  do i need 4 of these resistors, one wired in series onto the switch wire Â

so a ballast pack limits the peak current  so can i still add the 4.7 ohm resistor to the system and run these low impedance injectors

what wattage of resistor should i use  will get values tomorrow from orginals and the ones i will be using

what i mean the standard injectors are high impedance and i want to run these low impedance injectors as they are the correct size for what i need  can i add in a resistor to increase the value to the same as high inpedance injectors and will the ecu drivers be ok with it

can the link ecu which runs high impedance injectors as standard  can i add in a resistor in line to bring up the value to run these low impedance injectors as requiring 650cc instead of 440cc as going to running a garrett gt2860rs turbo shortly

i have a possum link ecu running on a ver 4 engine  can the the ecu run the later throttle body and idle speed control valve as new engine i am looking at has a ver 5 sti heads and a ver 4 inlet doesnt fit them  if not looks like i can cut the ver 4 inlet and weld up the 12mm extension gap to suit the ver 5 heads

yeah..........  once you have a good look at it, can you email me on the address above in this thread whats the damage is and cost of repair pleae and your opinion if it is worth repairing  cheers neil

hi simon  here is the package i sent to you  Â

hi simon  has the display unit arrived yet ?

hi simon  the link display unit is posted, post office say eta 5 days

form filled in when do i send it ? as iit is now sat 1126am local time scotland

that would be good if it is repairable  so i would post it from scotland to where  i can be contacted on [email protected]

tried the reboot make no difference at all opened up unit found white plug melted which the 2cables go onto and a centre pin with brown cable for power feed melted and pin going into black pcb to be very poor and loose  there is enoogh lenghth on cables to be reterminated but the black pcb looks it had a fry. is the black pcb available

whats the part number so i can get a price from my local dealer in kilmarnock

link display st up for possum link

link display connector

2nd photo

you will need the restrictor pill fitted , to make full use of the map should be 2mm hole in brass ball fitted between t piece and outlet from compressor

are you using the subaru boost solenoid or the manaul boost controller

will be interested in your differences  did you load the 6 row map into the 10 row software, or did you fill in missing gaps

did any of my maps from my link ecu help you with your lean issues

and sent you screen dumps as well

sent you the link ecu files

Your ecu is a newer version than my ecu