Jump to content

350z Plugin extension loom


Recommended Posts

Hello, I would like to use both CAN Lambda and have an extension loom to control two fan relays. 

Unfortunately the factory fans are controlled over CAN and with my setup I'd need a analogue way of triggering the relays. 

Is that possible with this ECU, I believe I already have the Can JST cable plugged into the ecu?

Thank you.

Link to comment
Share on other sites

It appears according to the help menu you have two 8 pin epansion plugs on the board as well with one of them having 3 aux outputs suitable to ground the trigger side of a relay to control your fans.  You'll need the XSL expansion loom for G4+/G4x plug-in ecus pn 101-0106.

Link to comment
Share on other sites

You could use Aux 6 & 7 at the ecu header or already in the engine bay in the O2 sensor plugs, or if it is the non up-rev model with only intake VVT then you will also have Aux 3 & 5 spare at the ecu header.  

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Create New...