Bebelracing Posted August 28, 2012 Report Share Posted August 28, 2012 Hello everybody. I'm acutally builiding my engine loom ( with spec55 wire, raychem DR25 heatshrink and Deutsch connectors) and I'm looking how to plug my AIM pista Dashboeard with the CAN line. If somebody can help me, it would be great! Thanks Quote Link to comment Share on other sites More sharing options...
Bebelracing Posted August 28, 2012 Author Report Share Posted August 28, 2012 Previously Belguendouz wrote: Hello everybody. I'm acutally builiding my engine loom ( with spec55 wire, raychem DR25 heatshrink and Deutsch connectors) and I'm looking how to plug my AIM pista Dashboard with the CAN line to the EXtrem G4 ECU If somebody can help me, it would be great! Thanks Quote Link to comment Share on other sites More sharing options...
Cameron Moore Posted August 30, 2012 Report Share Posted August 30, 2012 Hi Belguendouz, You will need to purchade part number 'CANDASH' from you local supplier. This will allow you to connect the AIM dash via CAN. -Cameron Quote Link to comment Share on other sites More sharing options...
Crispin Posted September 4, 2012 Report Share Posted September 4, 2012 Will this be true CAN so that PC Link can be used online at the same time as the dash? Quote Link to comment Share on other sites More sharing options...
Scott Posted September 4, 2012 Report Share Posted September 4, 2012 Hi Gustaf, Yes, you can have your dash connected over CAN and PCLink connected at the same time. Quote Link to comment Share on other sites More sharing options...
Scott Posted September 5, 2012 Report Share Posted September 5, 2012 Hi Gustaf, The earliest mention of CAN that I can find is in firmware version 4.8.0, however improvements have been made since then, so I recommend running the latest release version, 4.9.3 ECUs with serial numbers greater than 10000 are CAN enabled, this is not just a firmware change, In the G4 range the RX, Storm and Xtreme are capable of CAN. For ECUs with a serial number of less than 10000 the ECU can be returned to us and we can perform the upgrade. Yes, a G3 plus running G4 firmware is capable of having the upgrade performed. Cheers, Scott. Quote Link to comment Share on other sites More sharing options...
Scott Posted May 6, 2013 Report Share Posted May 6, 2013 Hi Matt, Correct, your ECU would need a CAN upgrade before being able to use CAN communication. Please email [email protected] to organise this if you wish to go ahead. Cheers, Scott Quote Link to comment Share on other sites More sharing options...
Matt Dunn Posted July 15, 2013 Report Share Posted July 15, 2013 I have an AIM dash currently running on serial and it works well. The ECU has had the CAN upgrade and so are now looking to get it sorted so we don't have to keep unplugging the dash to download data from the ECU. I have the two can wires from the ECU and the two from the dash, is there a problem hooking up the CAN lines without disconnecting the serial wires? Can I have them both connected but just select to run off CAN instead of the serial?    Quote Link to comment Share on other sites More sharing options...
Simon Posted July 15, 2013 Report Share Posted July 15, 2013 You can leave the serial wires there but they might cause connection issues when trying to connect the PC with dash connected. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.