Mohsin Posted April 4, 2016 Report Share Posted April 4, 2016 Just updated my pc link software version and now I'm getting this error and the software freezes stops working what's wrong with it any help?attachment below Quote Link to comment Share on other sites More sharing options...
Simon Posted April 5, 2016 Report Share Posted April 5, 2016 Hi MohsinWhat are you working with or doing just prior to it going slow/ locking up or bring up the error. Quote Link to comment Share on other sites More sharing options...
Mohsin Posted April 5, 2016 Author Report Share Posted April 5, 2016 as i connect it to my link ecu and save the file this error pop ups and the software freezes i tried reinstalling but same problem as i tried the previous version that was working fine then i get back to the new version and getting this error again. Quote Link to comment Share on other sites More sharing options...
Scott Posted April 5, 2016 Report Share Posted April 5, 2016 Before you re-installed did you delete the PCLink folder from your hard drive? Some files (layout files, etc) are not replaced when doing a re-install. The default location of the directory is C:\Link G4 Quote Link to comment Share on other sites More sharing options...
T4700 Posted April 5, 2016 Report Share Posted April 5, 2016 But before deleting dont forget to backup your calibration files if they are stored in this folder... Scott 1 Quote Link to comment Share on other sites More sharing options...
pugsparked Posted May 24, 2016 Report Share Posted May 24, 2016 I had trouble to update G4 + in a EvoVIII, removing the contact gave me update error.The solution was to remove the contact and also negative battery. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.