simonjob Posted March 28, 2018 Report Share Posted March 28, 2018 i have a set of bosch 1650cc injectors and was wondering how do I go about entering the dead times in to the ecu I have been supplied with this dead time table but the link one has more voltages in it? do I just enter the offset in the voltages and then do the table smother out and see how it goes? Quote Link to comment Share on other sites More sharing options...
Brad Burnett Posted March 28, 2018 Report Share Posted March 28, 2018 if you have a fuel pressure sensor wired into the ecu, I would set it up with a 3d table and enter the dead times just as they are there. If the injectors are very close to the Injector Dynamics 1700cc injectors, i would see how close this data is to them and maybe just use the ID data as it is more complete and will work better if trying to use the modelled fuel mode. Quote Link to comment Share on other sites More sharing options...
simonjob Posted April 1, 2018 Author Report Share Posted April 1, 2018 ok so there is no way to change the table to just use the voltages in the injector sheet table. Quote Link to comment Share on other sites More sharing options...
rrob Posted April 1, 2018 Report Share Posted April 1, 2018 Right click, axis setup. Quote Link to comment Share on other sites More sharing options...
simonjob Posted April 1, 2018 Author Report Share Posted April 1, 2018 yeah i have tryed that it is locked out and wont let me do it but i think i have it sorted now thanks for all the info Quote Link to comment Share on other sites More sharing options...
Adamw Posted April 1, 2018 Report Share Posted April 1, 2018 5 hours ago, simonjob said: yeah i have tryed that it is locked out and wont let me do it but i think i have it sorted now thanks for all the info For future reference, you turn on the 3D deadtime table, then your axes will be user configurable - you can turn the 2nd axis off if you dont want 3D. Quote Link to comment Share on other sites More sharing options...
simonjob Posted April 14, 2018 Author Report Share Posted April 14, 2018 ok cool thanks ill give it a go Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.