Toroddandre Posted May 16, 2016 Report Share Posted May 16, 2016 Hello.I am looking for someone who can help me a little bit. I have bought a car with Link G4+ Storm. Unfortunately there was no cable with the car, tuning cable that is.After some research I can't find a pinout diagram for the plug. I know the ecu have a built-in usb-uart chip.. so in reality I need the pins ground, vdc, data - and data +.Can anyone with this cable nearby measure witch usb pin corresponds to witch pin on the cam end. That would also e quite helpful..Btw, it is not the same as the can/dash plug. Witch is explained in the help file. This is the plug marked "usb" Quote Link to comment Share on other sites More sharing options...
Scott Posted May 17, 2016 Report Share Posted May 17, 2016 I've just used a multi-meter on my tuning cable to work out the pins.Pin 5 is VCCPin 4 is D-Pin 3 is D+Pin 6 is GND. integrale8v 1 Quote Link to comment Share on other sites More sharing options...
Toroddandre Posted May 18, 2016 Author Report Share Posted May 18, 2016 Thank You so much. :-) Quote Link to comment Share on other sites More sharing options...
Toroddandre Posted May 18, 2016 Author Report Share Posted May 18, 2016 A short question, is this looking on cable end or on ECU connector? I can't get it to work, I think I might got a faulty ecu, can someone upload a picture of the inside of the ecu? It looks like the connector have been replaced and I want to make sure the connectors are correct, and the wiring Quote Link to comment Share on other sites More sharing options...
Toroddandre Posted May 18, 2016 Author Report Share Posted May 18, 2016 It my look like the USB->UART chip CP2102 is broken.. is there any chance that the EEPROM on this chip is possible to obtain somewhere? Quote Link to comment Share on other sites More sharing options...
Scott Posted May 19, 2016 Report Share Posted May 19, 2016 Hi, if the chip is faulty the unit will need to be returned to us for repair. If you have the G4+ Storm blue is is also possible to tune through the serial connection if your PC/laptop supports this. Quote Link to comment Share on other sites More sharing options...
Fabio_dxb Posted May 22, 2019 Report Share Posted May 22, 2019 Hello, sorry to bring this up again. the pinout on the can end is the same on the newer ecus? Quote Link to comment Share on other sites More sharing options...
Simon Posted May 23, 2019 Report Share Posted May 23, 2019 Yes it is unchanged Quote Link to comment Share on other sites More sharing options...
Adamw Posted May 23, 2019 Report Share Posted May 23, 2019 I have a vague recollection that the pinout posted above by Scott may be wrong. Please check this one: Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.