ABS CAN ID

[Felix Garcia]

Hello, this is Felix from Barcelona, Spain

 

I´m building a track day car with my oem abs module TEVES MK60 , no a lot of info from this ABS module

I need pinout list (for identify CAN H CAN L and fault light)

and a CAN ID for speed wheels sensors to send to LINK ECU

Any one have that info?

Thanks

[integrale8v]

You will find it on the E46 m3: http://www.bmwtech.ru/wds/release/en/index.htm

 

For wheelspeed just set up the Canbus with the "Mini" config that works on the E46 Mk60.

[Felix Garcia]

Thanks a lot! 

Very usefull info integrale8v

Link staff, can share id channels config of Mini (speed sensors) to use the same CAN bus cable to abs and dash??

 

[Simon]

As long as the expected ID's are the same and the speed is the same for both then yes this should be able to be done.

[kiwi-racer]

Hi, I was searching and found this old thread. 

I see two Mini Modes.. But I need to mix it with other stuff on my bus..  I don't suppose anyone has a screen shot or config file I can load with the TEVES MK60 Can definitions ? 

This is a standalone use, I have a box which "wakes up" the ABS controller and it broadcasts it's wheel speed data at 500K 

[kiwi-racer]

I found this from a friend, posting what he shared so others can use this. 

[Adamw]

No that doesnt look right and the stream is no good without the CAN ID's shown anyway.  The offset of -5 would make the wheel speed overflow to ~6500kmh when not moving.  You can download my E46 basemap with the correct CAN setup from this post:  

 

[kiwi-racer]

Humm..  how do I open a .pclr file ? 

I have the G5 software

[dx4picco]

install g4+software too to open the map